re-configure cluster
Fri, 07/13/2012 - 09:40
I installed Couchbase for Windows and then configured the cluster using the web interface. I would like to retry the configuration using the command line (cluster-init). Is there a way to do this without doing a full uninstall? I don't want to re-run cluster-init over the existing install as I first want to test if the cluster exists before running the init.
Not an officially supported procedure, but should work, would be to delete the "config", "logs" and "data" directory from your installation while the service is shut down. Upon restart, it will revert back to what it would have been at a fresh install. Usually, the directories do not need to exist, but you may want to clean them out and just leave them there in case there's something different here on Windows.